Vehicle Reviews | Vehicle News | Vehicle Information

To program a transmitter, there are 3 modes within the remote control door lock receiver.

• Add mode: This mode is used for adding new or additional transmitters.

• Rewrite mode: This mode is used to erase all of the previously programmed transmitters and should be used when installing a new receiver.

• Confirmation mode: This mode is for confirming how many existing transmitters are registered before adding any transmitters.

To begin programming, follow the procedure.

Set the following conditions:
• Ignition off and ignition key out of cylinder.

• All doors closed except drivers door.

• All doors unlocked.

Insert the ignition key into the key cylinder momentarily and remove it.
Using the switch in the drivers door, move the switch to LOCK-UNLOCK 5 times at approximately 1 second intervals within 40 seconds.
Close the drivers door, then open it.
Again, move the switch to LOCK-UNLOCK 5 times at approximately 1 second intervals within 40 seconds.
Insert the ignition key into the key cylinder.
Turn the ignition switch from ON-LOCK at approximately 1 second intervals for 1-3 times according to the desired mode.
• 1 time for add mode

• 2 times for rewrite mode

• 3 times for confirmation mode

Remove the ignition key from the key cylinder.
• If the add or rewite mode has been selected, the doors will lock-unlock once or twice at 1 second intervals, once for add mode or twice for rewrite mode.

• If the confirmation mode is selected, the doors will lock-unlock 0-4 times at 2 second intervals to inform the technician of the number of transmitters programmed.

Press a transmitter button for 2 seconds. The doors will lock-unlock once at a 1 second interval to inform the technician that the signal has been received from the transmitter.
Close the drivers door, then open it.
Press a transmitter button for 2 seconds. The doors will lock-unlock once at a 1 second interval to inform the technician that the signal has been received from the transmitter.
• If the doors lock-unlock once, the transmitter programming has been completed. Go to step 9 to continue programming for additional transmitters.

• If the doors lock-unlock twice, the transmitter programming is not complete. Go to step 9 to begin the transmitter programming again.

If any of the following conditions occur during programming, the remote control door lock receiver will return to normal operation:

• The drivers door remains closed.

• 20 seconds elapses with no input to the RKE module.

• The ignition key is inserted into the key cylinder.

• 4 transmitters have been programmed at once.